Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál Strana 681

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 820
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 680
Paramacros
Chapter 20
20-37
#5751 to 5763
Home Marker Tolerance
These parameters are read only. They correspond to the current home m arker
tolerance. These parameters will contain the tolerance value at power turn on
and will represent 3/8 of an electrical cycle of the feedback device converted
to current axis programming units (inch/metric, degrees or revolutions).
5751 Axis 1 homemarkertolerance 5757 Axis7 home markertolerance
5752 Axis 2 homemarkertolerance 5758 Axis8 home markertolerance
5753 Axis 3 homemarkertolerance 5759 Axis9 home markertolerance
5754 Axis 4 homemarkertolerance 5760 Axis10 home markertolerance
5755 Axis 5 homemarkertolerance 5761 Axis11homemarkertolerance
5756 Axis 6 homemarkertolerance 5762 Axis12 home markertolerance
Use the paramacro parameters of the control to allow communication of
values between the PAL program and the part program. This is done by
assigning values to specific paramacro parameters or PAL flags. They are:
Input parameters - use these parameters to transfer data from PAL to
the part program
Output parameters - use these parameters to transfer data from the part
program to PAL. Some applications use the output flags to transfer data
from PAL to the part program as needed
Input Flags:
There are four-integer or three-integer and 32-bit pattern input parameters
available. The part program can only read the values assigned to these
parameters; it cannot write values to them. The paramacro input
parameters available to the part programmer are:
#1000 - #1031 and #1040 - #1071.
Use these paramacro PAL parameters to display the binary equivalent
of the integer assigned to #1032. #1000 is the first bit, #1001 is the
second bit, #1002 is the third bit, and so forth up to parameter #1031
(which is the 32nd bit). The second set of param eters, #1040 --
#1071, functions the same way.
#1032 -- #1035 and #1072 -- #1075
20.3.4
PALParameters
Zobrazit stránku 680
1 2 ... 676 677 678 679 680 681 682 683 684 685 686 ... 819 820

Komentáře k této Příručce

Žádné komentáře