Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál stáhnout pdf (Strana 296)

100

101

Introduction to Programming

Chapter 10

10-18

Table 10.A

How the Control Interprets Numeric Values

Position Interpreted by the control

Programmed X Value TZS Disabled

LZSDisabled

TZSDisabled

LZSEnabled

TZSEnabled

LZSDisabled

X123456. ERROR ERROR ERROR

X12345.6 12345.60 12345.60 12345.60

X1234.56 1234.56 1234.56 1234.56

X123.456 123.45 123.45 123.45

X12345 12345.00 123.45 12345.00

X012345 ERROR 123.45 1234.50

X123456 ERROR 1234.56 12345.60

X1234567 ERROR 12345.67 12345.67

X12345678 ERROR ERROR ERROR

Important: If backing up a table using a G10 program (such as the offset

tables or coordinate system tables), keep in mind the G10 program output

is generated in the current format of the control (LZS or TZS). If you

intend to transport this table to a different machine it must also be using the

same format.

Your system installer can also set an AMP parameter to generate an error

or use a value of zero for characters that are programmed without numeric

values. If this AMP feature is disabled, programming:

GX; rapid move to X zero

M; program stop

would result in the actions described in the comments following the blocks.

If you enable the feature, the error “NUMERIC MISSING” would have

occurred upon execution of either of those blocks.

In alphabetical order, Table 10.B shows the addresses for words that are

recognized by the control, their t ypical formats, and their general

meanings. Since most of these formats are configured in AMP, see the

documentation prepared by your system installer.

You can alter many of the addresses themselves in AMP. This table

assumes the most common names (such as X and Z for the main axes).

Alterable addresses are indicated by the note “AMP assigned”.

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 819 820

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál Strana 296

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra