Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál stáhnout pdf (Strana 276)

Communications

(softkey level 3)

Copy Parameters Screen

COPY PARAMETERS

FROM: (Program Name)

TO: (Selected Port Name)

DEVICE: FACIT N4000

BAUD RATE: 2400

PROTOCOL: LEVEL_2*

OUTPUT CODE: ASCII

AUTO FILENAME: NO

STOP PRG END: YES

PROGRAM END: M02, M30

Important: Press {CANCEL} to abort the copy operation at any time.

To verify that a part program stored in memory matches a source program

stored in memory or on a peripheral device:

1. If one of the programs to either verify or verify against is on a

peripheral device, make sure that the peripheral device is connected

to the correct serial port and that the port is configured for that device

(see page 9-4).

2. Press the {PRGRAM MANAGE} softkey.

Verifying Part Programs

Against Source Programs

Žádné komentáře

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál Strana 276