Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál stáhnout pdf (Strana 398)

100

101

AxisMotion

Chapter 12

12-26

Example 12.16

Radius and Chamfer with QuickPath Plus

N10Z25.X0.F.1;

N20G01A90,C2.;

N30Z15.X20.A180,R5.;

N40X40.;

N50Z5.;

Figure 12.17

Results of Radius and Chamfer, Example 12.16

40.0

20.0

2.0

R5.0

10.0

20.0

5.0

12031-I

Considerations with Chamfering and Corner Radius

If the control is executing in single block mode, t he control enters the

cycl e stop state after executing the first block and

the adjacent chamfer

or corner radius

If non-motion blocks are programmed separating t he two intersecting

blocks for the corner radius and chamfer features, the control executes

the chamfer or radius immediately after the first block. The non-motion

blocks are executed after the control has executed the chamfer or radius

Any negative signs programmed with the ,C-- or ,R--words are ignored.

The absolute value of this word is used to cut the chamfer or radius. For

example ,C-10 is executed as ,C10

An error is generated if the length of a chamfer is larger than the

programmed length of the first or second move, or for corner rounding

if the programmed corner radius is so large that the tangent point on

both of the two programmed blocks does not exist

1 2 ... 393 394 395 396 397 398 399 400 401 402 403 ... 819 820

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál Strana 398

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra