Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál stáhnout pdf (Strana 118)

100

101

Manual/MDI Operation Modes

Chapter 4

4-14

Figure 4.6

Program Display Screen in MDI Mode

PRGRAM

MANAGE

OFFSET MACRO

PARAM

PRGRAM

CHECK

SYSTEM

SUPORT

E-STOP

PROGRAM[ MM ] F 00000.000 MMPM

X 00000.000 S 0

Z 00000.000 T 1

U 00000.000

W 00000.000

MEMORY MDI STOP N 99999

(First 4 blocks

of MDI shown here)

(PAL messages)

You can call subprograms or paramacros within an MDI program;

however, there are limitations to the allowable commands. See chapter 10

on subprograms or chapter 20 on paramacros for details on illegal MDI

commands for these features.

Operating procedures in the MDI mode are as follows:

1. W ith the control in MDI mode, the control is ready to accept standard

programming blocks.

2. Key in programming blocks (see the programming section of this

manual beginning with chapter 10). Each block, a maximum of 62

characters long, must be separated with an end of block character

[EOB]. The blocks entered appear in the input area of the screen

(lines 2 and 3). You should enter the complete MDI program on

these lines since once you send the blocks to control memory, you

cannot edit or add-to them.

4.8.1

MDI Basic Operation

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 819 820

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra Uživatelský manuál Strana 118

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 8520-GUM 9/Series CNC Grinder Operation and Progra