Rockwell-automation AADvance Controller Configuration Guide Uživatelský manuál stáhnout pdf (Strana 131)



Document: 553633

ICSTT-RM405f-EN-P

Issue 07

5-33

AIM_HART_FULL_01.

ELAPSED

DINT

Elapsed time in ms.

since last valid non

passthrough

communication

This element resets to zero whenever

fresh data is received. The data is

refreshed approximately every four

seconds for a small system. This rate

proportional to the system size and the

number of HART devices in use, so it

will be slower on larger systems. If

HART Passthrough is enabled then no

fresh data is received.

AIM_HART_FULL_01.

PASSTHROUGH

BOOL

Passthrough

Communication

status

TRUE: Passthrough in progress

FALSE: Passthrough not in progress

Note: At least one CIP Produce variable must be defined. If there are no CIP

produce/consume variables the CIP stack does not get activated. Refer to the CIP

topics in this document on how to set up CIP produce/consume variables.

Configure HART for Field Device Monitoring

To configure the Analogue input Channels to monitor field devices that support the

HART protocol do the following:

1) Create HART variables within the Dictionary; set the type to T9K_AI_HART.

2) Go to the Equipment Tree View and select an Analogue Input or Analogue

Output module. Click on the HART tab.

 The example below is an Analogue Input module.

3) Select a Channel, then click .

4) Choose the T9K_AI_HART variable.

5) Wire this variable to each channel that has a HART device using a Tag name, click

OK.

6) Return to the Equipment Tree View, select a channel

7) Select the HART tab; put a tick in the box labeled Enable HART on this

Channel, click Apply

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 285 286

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation AADvance Controller Configuration Guide Uživatelský manuál Strana 131

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation AADvance Controller Configuration Guide