Rockwell-automation 22-COMM-C ControlNet Adapter Uživatelský manuál stáhnout pdf (Strana 39)

Configuring the I/O 4-5

Figure 4.7 Module Properties Screen

3. Edit the following information about the adapter:

4. Under Connection Parameters, edit the following:

Enter the number of words that are required for your I/O in the Input

Size and Output Size boxes. The size will depend on the I/O that you

enabled in the adapter. This information can be found in Parameter

12 - [DSI I/O Cfg] in the adapter. Table 4.A

shows common

configuration Input/Output sizes.

In our example, we entered “4” in the Input Size and “2” in the

Output Size boxes because the Operating Mode Jumper on the

adapter is set to “1x” (Single mode, which is the default). Logic

Status/Feedback uses 2 words of input and an additional 2 words of

input are reserved for ControlNet bridge overhead. Logic Command/

Reference uses 2 words of output.

Box Setting

Name A name to identify the adapter and drive.

Comm Format Data - INT (This setting formats the data in 16-bit words.)

Node The node address setting of the adapter.

Box Assembly Instance Size

Input 1 (This value is

required.)

The value will vary based on your application

(setting of Parameter 12 - [DSI I/O Cfg]). It will

contain 2 additional words for ControlNet bridge

overhead. Refer to Table 4.A

Output 2 (This value is

required.)

The value will vary based on your application

(setting of Parameter 12 - [DSI I/O Cfg]). Refer

to Table 4 . A

Configuration 6 (This value is

required.)

0 (This value is required.)

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 163 164

Žádné komentáře

Rockwell-automation 22-COMM-C ControlNet Adapter Uživatelský manuál Strana 39