
Ethernet-to-DeviceNet Linking Device 15
Rockwell Automation Publication 1788-IN055C-EN-P - September 2011
The following figure shows a flowchart describing how the IP configuration is
determined when the linking device is powered up.
You can enable these values using the linking device’s IP Configuration web
page. Refer to Setting the IP Address Using By Using the Web Page on
page 16.
Valid
Conguration
in Flash Memory?
DHCP
Cong
Received?
Valid
Conguration
File?
DIP Switch = 0
DHCP
Enabled?
IP = 192 168.1.n
Sub = 255.255.255.0
No Gateway
Remain oine
Use Valid (stored)
IP address
Request cong
from DHCP/
BOOTP Server.
Timeout 30 secs
Start
Stop
No
Ye s
No
No
No
No
Use received
conguration
Ye s
Ye s
Ye s
Ye s
Komentáře k této Příručce