Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Uživatelský manuál stáhnout pdf (Strana 12)

12 Ethernet-to-DeviceNet Linking Device

Rockwell Automation Publication 1788-IN055C-EN-P - September 2011

Configure the Linking Device IP Address

Several methods may be used to set the IP Address. These methods include the

following:

• IP address configuration DIP switch

• DHCP protocol

• Web pag e

• RSLogix 5000 software, version 13 or later), and 1788-EN2DN Linking

Device, revision 2.x or later

Setting the IP Address with the Configuration DIP Switch

A configuration DIP switch on the end of the linking device lets you set the IP

address. If the configuration DIP switch is set to 1 (in the up position, as shown

in the following figure), when power is applied to the switch, the value of the

switch creates the IP address of 192.168.1.1.

IP Address Configuration DIP Switch

IMPORTANT

The numbers that appear above the switches on the DIP switch do not

correspond to bit locations in the address value. The numbers on the switch

are opposite the address value bit locations; for example, bit 0 is set by

switch 8.

23456781

456

31421-M

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Žádné komentáře

Rockwell-automation 1788-EN2DN Ethernet-to-DeviceNet Linking Device Uživatelský manuál Strana 12