Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Uživatelský manuál stáhnout pdf (Strana 50)

50 Rockwell Automation Publication IASIMP-QS034A-EN-P - October 2012

Chapter 3 FANUC CNC Configuration

3. Use the arrow keys on the MDI panel to move to the desired

selections.

4. Prior to setting the parameter, be sure that MDI modes has been

selected by pressing the button on the CNC main panel.

5. Enter 1 from the numeric entry, then press INPUT to set the

parameter write enable bit (PWE, 8900#0). This lets you set the

parameters, and configure the CNC for use.

6. Setting this may cause an alarm to be triggered and displayed.

Cancel the alarm by pressing RESET on the MDI Panel. You will

then have to open the SETTING screen again as described above.

7. Turn the parameter write enable key switch to the on position.

IMPORTANT

This will take affect after the initial program has

been downloaded later in this chapter.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 277 278

Žádné komentáře

Rockwell-automation IASIMP Computer Numerical Control (CNC) Machining Uživatelský manuál Strana 50