Rockwell-automation DAG6.5.8 APPLICATION GUIDE SCADA SYSTEM Uživatelský manuál Strana 297

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 420
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 296
Publication AG-UM008C-EN-P - February 2005
Configuring Modems 8-31
All ESTeem model 192 wireless modems have the following features
or available options:
19,200 bps RF data rate
integral digi-repeater
frequency of operation programmable software
receiver squelch programmable software
remote programmability of all features over the RF, infrared or
dial-in phone interface
radio diagnostic programs included
radio self-test
packet monitor
received signal-to-noise ratio
received signal strength output (optional)
infrared communication port for local programming and
diagnostics
phone communication port for remote programming and
diagnostics (optional)
To connect an Allen-Bradley processor to these modems, follow these
specifications for:
cable pin assignments
switch settings
For software configuration information, refer to ESTeem Engineering
Report #97-001.
Cable Pin Assignments and Dip Switch Settings
ESTeem radio modems require a RS-232, 25-pin male D-shell
connector with the pin assignments shown in
. on the following page.
Refer to Table 8.20 and Table 8.28 for the RS-232 dip switch settings.
Zobrazit stránku 296
1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 419 420

Komentáře k této Příručce

Žádné komentáře