Rockwell-automation 592- E300 Overload Relay User Manual Uživatelský manuál Strana 116

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 424
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 115
116 Rockwell Automation Publication 193-UM015B-EN-P - June 2014
Chapter 5 Protective Trip and Warning Functions
Table 101 - L3 Under Current Trip Level (Parameter 273)
L3 Under Current Warning
The E300 Electronic Overload Relay will indicate an L3 Under Current warning
if:
No warning currently exists
L3 Under Current Warning is enabled
Current is present
The Under Current Inhibit Timer has expired
L3 Percent FLA (Parameter 49) is less than the L3 Under Current
Wa
r
n i ng Le ve l
When the L3 Under Current Warning conditions are satisfied, the:
TRIP/WARN LED will flash a yellow 10-short blink pattern
Bit 9 in Current Warning Status (Parameter 10) will set to 1
Bit 1 in Device Status 0 (Parameter 20) will set to 1
Any relay outputs configured as a Warning Alarm will close
L3 Under Current Warning Level
L3 Under Current Warning Level (Parameter 274) allows the user to define the
current at which the E300 Electronic Overload Relay will indicate a L3 Under
Current warning. It is user-adjustable from 10…100% for the FLA Setting
(Parameter 171).
Default Value 35
Minimum Value 10
Maximum Value 100
Parameter Type USINT
Size (Bytes) 1
Scaling Factor 1
Units %FLA
IMPORTANT
The Under Current Inhibit Timer starts after the maximum phase of load
current transitions from 0A to 30% of the devices minimum FLA setting. The
E300 Electronic Overload Relay does not begin monitoring for an under current
condition until the Under Current Inhibit Time expires.
IMPORTANT
For any given application, the practical limit of the L3 Under Current Trip Level
(Parameter 273), will be dependent on the FLA Setting and the lower limit of
the E300 Electronic Overload Relay’s current measurement capability
Zobrazit stránku 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 423 424

Komentáře k této Příručce

Žádné komentáře