Rockwell-automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Commun Uživatelský manuál stáhnout pdf (Strana 19)

Rockwell Automation Publication 20COMM-UM015B-EN-P - July 2013 19

Installing the Adapter Chapter 2

• See Appendix A for the number of CIP connections supported by the 20-

COMM-ER adapter.

• Verify that you have all required equipment. See Required Equipment

page 13.

Setting the Web Pages

Switch

To use the adapter web pages, the Web Pages Switch must be set to its ‘Enable

Web’ position. For information to enable or disable web pages for an adapter, see

Setting Web Access Control

on page 42.

Important:A new switch setting is recognized only when power is applied

to the adapter, or the adapter is reset. If you change a switch

setting, cycle power or reset the adapter to apply the change.

Set the Web Pages Switch (SW4 in Figure 2

) to enable or disable the adapter web

pages. By default, the adapter web pages are disabled. For complete details on

adapter web pages, see Viewing the Adapter Web Pages

on page 153.

Figure 2 - Setting Web Pages Switch (only Series B Adapter)

ATTENTION: Risk of equipment damage exists. The adapter contains

electrostatic discharge (ESD) sensitive parts that can be damaged if you do

not follow ESD control procedures. Static control precautions are required

when handling the adapter. If you are unfamiliar with static control

procedures, see Guarding Against Electrostatic Damage, publication 8000-

4.5.2.

Web Pages

Switch

Up Position =

Disable

Down Position =

Enable

Setting Description

Down (OFF) position Web server enabled

Up (ON) position Web server disabled (as shipped)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 237 238

Žádné komentáře

Rockwell-automation 20-COMM-ER 20-COMM-ER Dual-Port EtherNet/IP Commun Uživatelský manuál Strana 19