Rockwell-automation SA3100 Distributed Power System Drv Config,Program Uživatelský manuál stáhnout pdf (Strana 35)

Configuring the UDC Module, Regulator Type, and Parameters

2-23

The Minimum Value must not be less than -32768. The Maximum Value must not be

greater than 32767. The Minimum Value must be less than the Maximum Value.

Note that the PMI meter ports have 8-bit resolution and are updated on the average of

every 1.0 milliseconds.

See the PMI Regulator instruction manual (S-3057) for more information about the

PMI meter ports. See section

3.7.2.1 of this instruction manual for information about

resolution of data.

PMI meter ports can also be set up on-line using the “Setup UDC” selection from the

Monitor menu as described in the AutoMax Programming Executive instruction

manual. If the meter ports are set up during parameter entry, the information is loaded

onto the UDC module in the AutoMax rack along with all other parameter data. The

meter port setup can then be changed on-line under “Setup UDC,” but this method

would not actually write over the PMI meter port setup that was loaded to the rack.

Instead, the new setup would be valid only until there was a Stop All or a power cycle,

in which case the original setup would be used to determine what data to send out of

the meter ports.

Table 2.5 – PMI Meter Port Parameters (Volts/Hertz)

• Port Not Used

• Voltage Reference (Volts)

• Voltage Reference (Counts)

• Voltage Feedback (Volts)

• Voltage Feedback (Counts)

• Frequency Reference (Hertz

∗

10)

• Voltage Auxiliary Reference (Volts)

• DC Bus Voltage (Volts)

• DC Bus Current (Amps

∗

10)

• Ground Fault Current (Amps

∗

10)

• Motor Voltage Feedback (Volts)

• Motor Current Feedback (Amps

∗

10)

• Output Frequency Hz

∗

10)

• User Analog Input (Counts)

• Speed Feedback (RPM)

• Carrier Frequency (KHz

∗

10)

• Application Data (Units)

• Flex Module 0 (Counts)

• Flex Module 1 (Counts)

• Flex Module 2 Channel 0 (Counts)

• Flex Module 2 Channel 1 (Counts)

• Flex Module 2 Channel 2 (Counts)

• Flex Module 2 Channel 3 (Counts)

• Flex Module 2 Channel 4 (Counts)

• Power Module Heat Sink Temp (°C)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 161 162

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation SA3100 Distributed Power System Drv Config,Program Uživatelský manuál Strana 35

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation SA3100 Distributed Power System Drv Config,Program