Rockwell-automation 9301 Series RSView32 Users Guide Uživatelský manuál stáhnout pdf (Strana 434)

100

101

Animating graphic objects  12–27

Using the Default Center Points

To use the default center points, select a button.

Why use the default center points? If you set the center of rotation

with the default center points, the object will rotate around the

same point even if the object is resized. For example, the top–

middle corner will always be the center of rotation no matter what

size the object is.

Specifying Coordinates

The default coordinates 0,0 are the center of the object; all

coordinate values are relative to the center. To specify coordinates,

do one of the following:

using the mouse, place the crosshair at the desired center of

rotation and select the button beside the coordinates field

type values in the coordinates field and then select the button

beside the field

5. Set the range of motion for the object.

To set the minimum, do one of the following and then select the

At Minimum check box:

click the Rotate tool and visually set the degree of rotation

type the desired degree of rotation (this value is relative to the

object’s current position). For clockwise rotation, use a positive

number. For counterclockwise rotation, use a negative number.

Rotate too

Rotate tool

1 2 ... 429 430 431 432 433 434 435 436 437 438 439 ... 768 769

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 9301 Series RSView32 Users Guide Uživatelský manuál Strana 434

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 9301 Series RSView32 Users Guide