Rockwell-automation 57C435 Processor Module, AutoMax Uživatelský manuál stáhnout pdf (Strana 51)

EĆ3

Corrective action: correct the problem in application software. Error code 47 can

be caused by performing a PUT on a closed port. Error code 4A can be caused

by attempting to use Ethernet functions with the standard operating system

loaded. To use Ethernet functions, you must load the Ethernet operating system.

Multibus and Processor Bus STOP ALL Error Codes

50 Onboard parity error

51Ć54 Onboard bus error or access violation

55 Multibus parity error during read access

56Ć58 Multibus access violation or bus error

60 Network interrupt allocation failed

61 Network receiving queue overflow

62 Network transmit queue underflow

Corrective action: reset by cycling power and reĆloading configuration and

application tasks. If the small green LED labeled OK" on the Processor module

faceplate is off, replace the Processor module. Correct any incorrect accesses in

application software. Systematically swap out hardware modules. For error codes

55Ć58, if none of the above correct the problem, try replacing the backplane.

DriveĆRelated Error Codes

The following error codes indicate a power circuit or external drive system fault.

After correcting the problem, reset the Processor module to clear the error code.

80 Instantaneous overcurrent fault

Ć armature current exceeded IOC_THRESH value in CML task

81 Line sync loss fault

82 Tach loss fault

Ć 40% armature voltage with less than 5% tach feedback

83 Overspeed/overvoltage fault

Ć CML task OSV_FDBK exceeded OSV_THRESH number

84 Hardware overspeed fault

Ć drive analog module potentiometer setting exceeded

by input voltage

85 External IET fault

Ć external fault input triggered

86 Phase rotation fault

Ć incorrect phasing

87 Shorted SCR detected in power module

Corrective action: troubleshoot power circuit and external drive system.

Configuration Error Codes

The following error codes usually indicate a discrepancy between the actual

hardware configuration and the I/O definitions in the configuration for the rack.

E0 TASK specified in configuration uninstalled,

at wrong priority, of wrong type, on wrong

Processor module; wrong spelling of TASK

E1 Invalid configuration, configuration not successfully downloaded.

E2 I/O referenced in configuration is missing.

E3 I/O referenced in configuration is missing. Invalid configuration,

configuration not successfully downloaded.

E4 Error building task, insufficient memory in Processor Module.

Invalid configuration, configuration not successfully dovvnloaded.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 57C435 Processor Module, AutoMax Uživatelský manuál Strana 51

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 57C435 Processor Module, AutoMax