Rockwell-automation 57C435 Processor Module, AutoMax Uživatelský manuál stáhnout pdf (Strana 22)

4Ć2

Processor in the rack is a M/N 57C430A or M/N 57C431, the

operating system(s) will be loaded at 9600 baud. At 9600 baud, it will

require approximately two minutes to load each operating system to

Processors in the rack. Although they are similar, the operating

systems for the 6010/6011 and 7010 Processor are different. If there

are 6010/6011 and 7010 Processors mixed in the same rack, loading

the operating systems will take approximately twice as long as it

would if there were only one type of Processor in the rack.

Follow the directions below to load the operating system(s) for all

Processor modules in the local rack at one time. You can then load

the operating system(s) to all racks on all networks in the system.

Note: If you load an operating system into a Processor(s) that

already contains one, the new operating system will write over

the existing operating system, and any tasks in the Processor(s)

will be deleted.

1. If you have not already done so, turn on the personal computer

and run the AutoMax Executive by typing

AUTOMAX2

AUTOMAX3

2. Turn on power to the rack. You will note that the leftmost

Processor module in the rack displays the letters L" and O"

(reading top to bottom). This code prompts you to Load the

Operating system. Because Processor modules have onĆboard

battery backup, you will need to reĆload the operating system

only when enhancements become available, when you change

the password for the rack using the PWOS.EXE utility or when a

Processor module in the rack is replaced.

3. If you have not already done so, connect the personal computer

to the leftmost processor in the rack, following the directions

in 4.4.

4. Enter a <CR> at the initial screen. If you are using AutoMax

Version 2, select F10 for Load Operating System". If you are

using AutoMax Version 3, select Load Operating System" from

the Commands menu. Note that you will see the message Local

OS invalid Ć Direct connection only" before you load the

operating system for the first time. The AutoMax Executive

software will load the operating system onto all Processor

modules in the local rack at the normal baud rate. The AutoMax

Executive will display on the screen the portion (%) of the

operating system that has been loaded.

5. When installation begins, the code L" O" will disappear from the

two sevenĆsegment LEDs on the leftmost Processor module. The

LEDs should be blank. If any error codes appear on the LEDs of

the leftmost Processor, the loading was not successful. Repeat

step 4 above.

6. You can now load the operating system to other racks in the

system connected to the local rack (the rack to which your

personal computer is connected) through 57C404A Network

Communication modules. For any network containing 57C404

Network Communication modules, you must connect directly to

each rack on the network to load the operating system (see steps

1Ć5 above).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 59 60

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 57C435 Processor Module, AutoMax Uživatelský manuál Strana 22

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 57C435 Processor Module, AutoMax