Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál stáhnout pdf (Strana 30)

2–8 Installing the Software

Publication 2706-6.2

Create CFG_KT.INI File

INTERCHANGE needs to know exactly what hardware you are

using, and how it is configured. This information is provided by a

configuration file (CFG_KT.INI) modified to match your own

installation.

1. Edit the file with any ASCII text editor. If you use the DOS text

editor, type:

EDIT C:\ABIC\BIN\CFG_KT.INI↵

The CFG.INI file that installs with INTERCHANGE includes

configurations for numerous cards. Lines preceded by a

semicolon (;) have been commented out. To activate your

interface card, edit and uncomment the appropriate options by

removing the semicolon at the beginning of the line.

If you are using a card other than the 1770-KF2 go to step 2

below. If you are using the 1770-KF2 communications interface

card, skip step 2 and go directly to step 3.

2. If you are using a card other than the 1770-KF2, the contents of

the CFG_KT.INI file should be similar to the format shown in the

sample file below. This sample is for a 1784-KT board:

[DTL_KT.Options] ①

PATH=C:\ABIC\BIN ②

③

[DTL_KT.1] ④

DEVICE=KT ⑤

MEMORY=C800 ⑥

PROTOCOL=DHPLUS ⑦

IRQ=5 ⑧

STATION=77 ⑨

NAME=DTL_KT 1 ⑩

In this file:

① This line identifies the file and prefaces a section of the file used to record

information common to all the communications interface cards on your system.

② PATH line that designates the directory where the INTERCHANGE server

programs are located. This will be the same value for all interface cards on your

system.

③ Blank line to separate sections and improve readability.

④ This line identifies the general class of hardware device (in this case a KT

device) and a logical pushwheel identifier of 1. Note: The DL40 Offline

Programming Software assumes that pushwheel 1 is used. Only use pushwheel

1 when communicating with the DL40 Offline Programming Software.

⑤ DEVICE line that specifies the exact communication interface card used.

Acceptable values include KT, KTX, KL, KT2, or PCMK.

⑥ MEMORY line that matches the dip switch settings on the interface card.

⑦ PROTOCOL line that identifies the protocol in use.

⑧ IRQ line that matches the dip switch settings on the interface card.

⑨ STATION line designates the octal station address on the communications link.

⑩ NAME is a unique string you define to specify to this configuration.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 148 149

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál Strana 30

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL