Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál stáhnout pdf (Strana 23)

 

Publication 2706-6.2

Installing the Software

This chapter describes how to install the DL40 Offline Programming

Software on your computer. It also explains the basic steps required

to configure your system for use with PassThrough on systems

equipped with an Allen-Bradley PLC capable of Remote I/O

PassThrough file transfers.

Section Page

Personal Computer Requirements 2–1

Package Contents 2–1

Installed Files 2–2

Memory Requirements 2–2

Memory Management 2–3

Installation 2–3

Basic Installation (without PassThrough file transfers) 2–4

Installing Software for DH+ PLC PassThrough 2–5

Installing Software for Ethernet PLC PassThrough 2–11

Starting the Program 2–13

Establishing Initial Non–network Communications 2–13

The minimum equipment required to install and run the Offline

Programming Software consists of an IBM compatible personal

computer (PC) with:

• a 386 (or higher) processor

• 640K RAM

• one 3

inch micro diskette drive

• a hard disk with at least 1 Megabyte of available space

• one open serial port (COM1 or COM2)

• one open printer port (LPT1, LPT2, LPT3, LPT4, COM1, or

COM2) for printing messages

• a printer

In addition to this manual, the Offline Programming Software

package consists of three disks and a number of documents.

They include:

• DL40 Plus Offline Programmer

• DL40 Plus PASSTHROUGH Drivers

• DL40 Plus INTERCHANGE Software

Chapter Objectives

Personal Computer

Requirements

Package Contents

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 148 149

Žádné komentáře

Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál Strana 23