Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál stáhnout pdf (Strana 26)

2–4 Installing the Software

Publication 2706-6.2

Use the following procedure to install the basic Offline Programming

Software files on an IBM PC. Note that prompts appearing here

represent a typical PC. The prompts you see on your computer may

vary slightly from those shown here.

Note: Do not automatically install all of the program disks. First

determine the type of installation you require and install just the

programs required.

1. If running in a Windows environment, restart your computer in

DOS mode. Windows NT users need to restart their computers

with a Windows 95 or less operating system.

2. Start your computer and log on to the hard disk (normally you

will see the DOS prompt C:>).

Note: Depending on your installation, your DOS prompt may be

different.

3. Insert the DL40 Offline Programmer disk into the micro drive.

Most often this will be the A: drive.

4. At the DOS prompt (C:>), type:

A:INSTALL↵

5. Follow the onscreen installation prompts until installation is

complete and the C:> prompt reappears. Note: If the Offline

Programming Software program is already on disk, you will be

able to overwrite the program during installation.

6. The installation procedure automatically creates a default

sub–directory which contains the Offline Programming Software

program. By default that directory is DL40. Change to that

directory by typing:

CD\DL40↵

Basic Installation

(without PassThrough)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 148 149

Žádné komentáře

Rockwell-automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL Uživatelský manuál Strana 26