Rockwell-automation 20-750-BNETIP BACnet/IP Option Module Uživatelský manuál stáhnout pdf (Strana 20)

20 Rockwell Automation Publication 750COM-UM005B-EN-P - June 2014

Chapter 2 Installing the Option Module

Applying Power

Apply power to the drive. The option module receives its power from the drive.

When you apply power to the option module for the first time, its topmost

‘PORT’ status indicator should be steady green or flashing green after an

initialization. If it is red, there is a problem. See Chapter 5

, Troubleshooting.

Start-Up Status Indications

After power has been applied, the drive STS (status) indicator can be viewed on

front of the drive and the option module status indicators can be viewed with the

drive cover open or removed (Figure 2

). Possible start-up status indications are

shown in Ta ble 1

Figure 2 - Drive and Option Module Status Indicators

ATTENTION: Risk of equipment damage, injury, or death exists.

Unpredictable operation can occur if you fail to verify that parameter

settings are compatible with your application. Verify that settings are

compatible with your application before applying power to the drive.

➊

➋

➌

➍

See Table 1 for

possible start-up

status indications.

Drive Control Pod

(drive shown with

cover removed)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Žádné komentáře

Rockwell-automation 20-750-BNETIP BACnet/IP Option Module Uživatelský manuál Strana 20