Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Uživatelský manuál stáhnout pdf (Strana 57)

Rockwell Automation Publication 1788-UM058B-EN-P - September 2014 57

Appendix A

Linking Device Display Status

The display of the linking device provides status and diagnostic data in one of

three page formats: main page, PA master page, or field device page. Use the Page

button behind the front cover to scroll through the pages (see Hardware Switches

Location on page 22 for location of the Page button).

Main Page

The main page is the default

display. The linking device returns

to this page after 10 seconds.

PA Bus A/B: Displays the bus

voltages on each port.

IP: Displays the current IP address

or BOOTP if enabled.

CNet MAC: Displays the current

ControlNet node address

(1788-CN2PAR linking device

only).

STS: Displays the status

(see Ta b l e 7

Table 7 - STS Status Descriptions

Status Message Description

ok No events.

new device found A new field device is on the bus.

redundancy ok Masters are synchronized.

redundancy err The master linking devices are out of sync.

bus A tripped PA bus A has tripped because of over current.

bus B tripped PA bus B has tripped because of over current.

SAFE MODE The linking device has been set into safe mode.

not owned No connection to a Logix controller.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

Žádné komentáře

Rockwell-automation 1788-EN2PAR EtherNet/IP and ControlNet to PROFIBUS Uživatelský manuál Strana 57