Rockwell-automation 1784-KTS_KTX_KTXD User Manual Communication Interf Uživatelský manuál stáhnout pdf (Strana 43)

Connect the Interface Card 4-9

1784-6.5.22 - November 1999

Connect the Card to an SLC 500 Processor

Figure 4.2 shows an example of a point-to-point link consisting of an SLC 500

processor and a programming station. This configuration requires the 1784-KTX

or -KTXD card and an SLC 500 processor. The SLC 500 CPU is connected

directly to the 1784-KTX or -KTXD card with a 1784-CP14 cable, as shown.

Figure 4.2 Communicating to a single SLC 500 using a point-to-point DH-485 link

To connect an SLC family processor to the KTx card, you:

1. Connect the termination resistor end of the CP14 cable to the KTx card.

2. Connect the RJ-45 connector directly to the phone-jack connector on the front

of the SLC processor.

To the 1784-KT

Card

SLC 500 Controller

1784-CP14 Cable

Personal

Computer

42140

6-pin Phoenix connector with

switchable termination resistor

RJ-45 connector

1784-CP14 cable

10.5 ft

(3.20m)

42141

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 95 96

Žádné komentáře

Rockwell-automation 1784-KTS_KTX_KTXD User Manual Communication Interf Uživatelský manuál Strana 43