Rockwell-automation 1763 MicroLogix 1100 Programmable Controllers User Uživatelský manuál stáhnout pdf (Strana 229)

Publication 1763-UM001D-EN-P - March 2011

Connecting to Networks via Ethernet Interface 227

If your network is divided into subnetworks that use gateways or routers, you

must indicate the following information when configuring channel 1:

• subnet mask

• gateway address

A subnet mask is a filter that a node applies to IP addresses to determine if an

address is on the local subnet or on another subnet. If an address is located on

another subnetwork, messages are routed through a local gateway to be

transferred to the destination subnetwork.

If your network is not divided into subnets, then leave the subnet mask field at

the default.

If you are Then

manually configuring channel 1

and have a network with subnets

• be sure the BOOTP enable field is disabled

• use your programming software to enter the

subnet mask and gateway address.

using BOOTP to configure channel

1 and have a network with

subnets

• be sure BOOTP is enabled

• include the subnet mask(s) and gateway

address(es)

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 255 256

Žádné komentáře

Rockwell-automation 1763 MicroLogix 1100 Programmable Controllers User Uživatelský manuál Strana 229