Rockwell-automation 1771-DBMEM1,1771-DBMEM2 INSTL.INST EEPROM MEMORY M Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení Rockwell-automation 1771-DBMEM1,1771-DBMEM2 INSTL.INST EEPROM MEMORY M. Rockwell Automation 1771-DBMEM1,1771-DBMEM2 INSTL.INST EEPROM MEMORY MOD. User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
BASIC Module EEPROM Memory
Module
(Cat. No. 1771-DBMEM1, -DBMEM2)
Installation Instructions
Check the contents of the package for.
8K byte EEPROM (1771-DBMEM1) –or–
32K byte EEPROM (1771-DBMEM2)
If any items are missing, contact your local Allen-Bradley office.
Use this publication as a guide when installing this memory module into
the 1771-DB/B BASIC module.
Before you can install the memory module you must remove the 1771-DB
module from the I/O chassis and disassemble the module.
Refer to the BASIC Module User Manual (pub. no. 1771-6.5.113) for
disassembly instructions.
ATTENTION: To avoid damaging the module with
electrostatic discharge:
Wear an approved wrist-strap grounding device or touch a
grounded object to discharge yourself before
handling any equipment. (Note that the wrist
strap is not supplied with the module.)
Do not touch backplane connectors or
connector pins.
If you configure or replace internal components,
do not touch other circuit components inside the module.
When not in use, keep components in a static-shielded bag.
Installation Notes
Before
Y
ou Begin
17991
Attach this end
to a good earth
ground.
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - BASIC Module EEPROM Memory

BASIC Module EEPROM MemoryModule(Cat. No. 1771-DBMEM1, -DBMEM2)Installation InstructionsCheck the contents of the package for.8K byte EEPROM (1771-DBM

Strany 2 - the Memory Module

Installation InstructionsEEPROM Memory Module2Follow these instructions to install your memory module.1. Remove the BASIC module from the I/O chassis.

Strany 3 - Installation Instructions

Installation InstructionsEEPROM Memory Module3JW2JW35. Set jumper JW2 (select PROM circuitry) to :6. For optimum BASIC module performance, set jumper

Strany 4 - With major offices worldwide

Installation InstructionsEEPROM Memory Module4With major offices worldwide.Algeria • Argentina • Australia • Austria • Bahrain • Belgium • Brazil • Bu

Komentáře k této Příručce

Žádné komentáře