Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Uživatelský manuál stáhnout pdf (Strana 32)

Publication 1753-PM001A-EN-P - November 2005

1-22 Connect to the GuardPLC Controller

Change the SRS of the

Controller

There are two ways to change the SRS of the controller:

From the Control Panel:

1. Choose Change System ID (SRS) from the Extra menu.

2. Enter the SRS.

3. Click OK.

Or follow Step 4: Get Communication Settings on page 1-9 and

Step 5: Change Settings via MAC Address on page 1-10.

TIP

If communication fails:

• check to make sure you entered the address

correctly.

• check that your PC is configured properly.

• anti-virus or firewall programs have blocked

communications.

• the cable is not connected or is not the correct

cable.

– A GuardPLC 1600 or 1800 controller can use

direct or cross-over cable.

– A GuardPLC 1200 or 2000 controller can use a

cross-over cable connected directly from a PC

to the controller or direct cables connected to

a switch or hub.

• your hardware (either the controller or the PC) is

not working.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 121 122

Žádné komentáře

Rockwell-automation 1753-PCS-PAR Using RSLogix Guard PLUS! with GuardP Uživatelský manuál Strana 32