Rockwell-automation SB3000 Configuration and Programming Uživatelský manuál stáhnout pdf (Strana 38)

3-20

SB3000 Drive Configuration and Programming

I/O Control Register 101/1101

The I/O Control Register contains the bits that control the EXT FLT LED on the PMI Processor, the auxiliary

output on the Resolver & Drive I/O module, and the loopback test.

External Fault LED Bit 2

The External Fault LED command bit is set

by the application task to turn on the EXT

FLT LED on the PMI Processor.

Hex Value: 0004H

Sug. Var. Name: EXT_FLT@

Access: Read/Write

UDC Error Code: N/A

LED: EXT FLT

Auxiliary Output Bit 4

The Auxiliary Output bit is set to turn on the

auxiliary output on the Resolver & Drive I/O

module in the PMI rack.

Hex Value: 0010H

Sug. Var. Name: AUX_OUT@

Access: Read/Write

UDC Error Code: N/A

LED: AUX OUT

UDC Module External Loopback Bit 15

The UDC Module External Loopback bit is

set to enable the external loopback test on

the UDC module's fiber-optic ports.

Hex Value: 8000H

Sug. Var. Name: UDC_LB@

Access: Read/Write

UDC Error Code: N/A

LED: N/A

the COMM B test. Note that this bit must be reset to 0 before the loopback

connector is removed from the UDC module's fiber-optic ports. Refer to the

Fiber-Optic Cabling instruction manual for specific instructions on performing the

loopback test.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 121 122

Žádné komentáře

Rockwell-automation SB3000 Configuration and Programming Uživatelský manuál Strana 38