Rockwell-automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Uživatelský manuál stáhnout pdf (Strana 21)

Installing the DeviceNet Adapter

3-3

3.3 Connecting the Adapter to the

Network

Step 1. Remove power from the network and drive.

Step 2. Use static control precautions.

Step 3. Connect a DeviceNet cable to the network, and route it

through the bottom of the SP600 drive. DeviceNet thin

cable with an outside diameter of 6.9 mm (0.27 in.) is

recommended. (See figure 3.5.)

Important:

Maximum cable length depends on data rate. Refer to

data rate

in the Glossary.

Step 4. Connect a 5-pin linear plug to the DeviceNet cable. Refer

to figure 3.3.

Note that a 10-pin linear plug is not supported. Use the

5-pin linear plug shipped with the adapter.

Step 5. Connect the DeviceNet cable to the adapter and secure it

with the two screws (see figure 3.4).

ATTENTION:

The drive may contain high voltages

that can cause injury or death. Remove all power

from the drive, and then verify power has been

removed before installing or removing a DeviceNet

adapter. Failure to observe these precautions could

result in severe bodily injury or loss of life.

Terminal Color Signal Function

5 Red V+ Power Supply

4 White CAN_H Signal High

3 Bare SHIELD Shield

2 Blue CAN_L Signal Low

1BlackV– Common

Figure 3.3 – Connecting a 5-Pin Linear Plug to the Cable

Red

White

Bare

Blue

Black

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 167 168

Žádné komentáře

Rockwell-automation RECOMM-DNET DeviceNet Adapter for use with DPI AC Uživatelský manuál Strana 21