Rockwell-automation FactoryTalk Historian SE 3.0 UniInt Interface User Uživatelský manuál stáhnout pdf (Strana 19)

UniInt Interface User Manual 13

Parameter

Description

/stopstat=digstate

/stopstat

/stopstat only is

equivalent to

/stopstat="Intf

Shut"

Optional

Default = no digital state

written at shutdown.

If the /stopstat parameter is present on the startup

command-line, then the digital state Intf Shut will be

written to each Historian Point when the interface is stopped.

If /stopstat=digstate is present on the command-line,

then the digital state, digstate, will be written to each

Historian Point when the interface is stopped. UniInt uses the

first occurrence in the table.

If neither /stopstat nor /stopstat=digstate is

specified on the command-line, then no digital states will be

written when the interface is shut down.

Examples:

/stopstat=shutdown

/stopstat="Intf Shut"

The entire digstate is enclosed within double quotes when

there is a space in digstate.

/uht_id=#

Optional

Default = Health tags are not

filtered by location3 unless

UniInt failover is used

The /uht_id=# command-line parameter is used to specify

a unique ID for interfaces that are run in a redundant mode

without using the UniInt failover mechanism. There are

several Rockwell Automation interfaces that are UniInt based

and implement their own version of failover. In order for health

tag(s) to be configured to monitor a single copy of the

interface, an additional parameter is required. If the

/uht_id=# is specified, only health tags with a location3

value = # will be loaded.

/uiinfops=s

Optional (not recommended)

Default = UI_IF_INFO

The /uiinfops command-line parameter is used in

conjuction with the Interface Informaiton point and is

described in more detail in the Interface Monitoring Points

section. The interface by default looks for a point with the

point source UI_IF_INFO and checks to see if the point is the

Interface Monitoring point. This point source can be changed

but if it is, the /uiinfops will have to be added to every

interface in order for the interfaces to find the Interface

Information point.

/uitrace=x

Optional

Default = no tracing enabled

If the /uitrace command-line parameter is specified, the

values and timestamps that are received by the interface are

also written to the log file. Tracing can be enabled for a

particular point by specifying /uitrace=x, where x is the point

number or tag name of the point to be traced. This parameter

should be used with caution because specifying this

parameter could cause the log file to become very large.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 107 108

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation FactoryTalk Historian SE 3.0 UniInt Interface User Uživatelský manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation FactoryTalk Historian SE 3.0 UniInt Interface User