Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Uživatelský manuál stáhnout pdf (Strana 96)

96 Rockwell Automation Publication 57RF-UM001A-EN-P - September 2011

Chapter 8

The RFID ICODE handheld interface acts slowly.

• The unit may be short of program memory or storage memory.

• Increase the amount of storage or program memory through the System

control in the Control Panel.

• You can also delete any unnecessary files.

I get little or no sound from the RFID ICODE handheld interface.

• Adjust the volume and sound properties via the Volume and Sound control

in the Control Panel.

The RFID ICODE handheld interface does not recognize a compact flash or

device card.

• The card is not installed or seated properly.

• Reinstall the card. There may be an unstable connection between the card

and the RFID ICODE handheld interface.

• Remove the card, clean the edge connector with a soft dry cloth, and

reinstall the card.

The RFID ICODE handheld interface goes into auto-suspend after a short

period of inactivity.

• As a default, the device will auto-suspend after two minutes of inactivity

while running on batteries and after thirty minutes of inactivity when

running on AC power.

• Adjust the power management properties via the Power control in the

Control Panel.

No sound is heard when you tap the touch screen or press a key.

• Volume setting is low or turned off.

• Check the volume slider in the Volume & Sound properties dialog box in

the Control Panel.

Error Codes

Initialization

The RFID ICODE handheld interface will return the following error codes if an

error occurs during initialization:

Value Description

100 Not initialized

101 Could not open COM port

102 Could not turn on auxiliary power

103 Could not initialize module

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 111 112

Žádné komentáře

Rockwell-automation 57RF RFID ICODE Handheld Interface User Manual Uživatelský manuál Strana 96