Rockwell-automation 4100 REC Resolver to Encoder Converter Installatio Uživatelský manuál stáhnout pdf (Strana 22)

Publication 999-126 - February 1996

Installation & Hook-Up 17

Figure 2.6

Terminal diagram

3. Using a small, flat-head screwdriver, turn the clamping screw

counter-clockwise several times.

4. Using a proper stripping tool, strip the wire insulation back on the

cable lead.

Important: All terminals accommodate a maximum of 14 gauge

wire.

5. Trim the cable lead so that 0.275 inches of metal wire is exposed.

6. Insert the cable lead in the appropriate terminal. Refer to the

proper figures for their locations.

7. Use the screwdriver to tighten the clamping screw to the proper

torque (0.25 N-m/2.2 in-lb.).

8. Verify that the cable lead does not pull out of the terminal.

Terminal open

Terminal closed

Clamping screws

Table 1: Terminal Steps

If the terminals are: Do this:

Not open Go to step 3

Open Go to step 4

Table 2: Cable Leads

If the cable lead: Do this:

Pulls out of the terminal Repeat steps 3 through 9 again

Does not pull out of the terminal Repeat steps 3 through 9 for the next

terminal

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 49 50

Žádné komentáře

Rockwell-automation 4100 REC Resolver to Encoder Converter Installatio Uživatelský manuál Strana 22