Rockwell-automation 4100 AEC Absolute Encoder Converter Installation Uživatelský manuál stáhnout pdf (Strana 19)

11 Publication 4100-UM052B-EN-P - October 2001

Chapter

Installation & Hook-Up

Chapter Objectives

Read this entire chapter before beginning to mount, connect, or wire

any of the components to the AEC. It is the responsibility of the

installer to see that the installation conforms to the directions in this

manual and local codes and procedures. This chapter covers the

following topics.

•

European Union Compliance

•

Mounting the AEC

•

Connecting the AEC to the 1394 GMC system

•

Connecting the AEC to the Compact motion controller

•

Connecting the AEC to the 1746-MO2AE

•

Wiring the SSI transducer to the AEC

•

Wiring the Control connector

•

An example of a Fault relay

•

Wiring the Power connector

Installing the AEC

The AEC is designed to mount in an electrical cabinet using the

flanges on its back panel. This installation method should be observed

for all applications. Before powering the AEC, make sure it has been

configured correctly and that the transducer(s) and control devices

(controller) are connected to it correctly.

Complying with European

Union Directives

The information contained in this document pertains to the Absolute

Encoder Converter (AEC), an Allen-Bradley product. If the AEC is

installed within the European Union or EEA regions and has the CE

mark, the following regulations apply.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 60 61

Žádné komentáře

Rockwell-automation 4100 AEC Absolute Encoder Converter Installation Uživatelský manuál Strana 19