Rockwell-automation 2711 Standard PanelView Operator Terminal User Man Uživatelský manuál Strana 265

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 292
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 264
Publication 2711-UM014G-EN-P - September 2008 265
Messages, Codes and Self-test Numbers Appendix B
16398 The Connection
Originator is
indicating it is in
Program Mode
Comm Warning The logic controller is offline (in
Program Mode). The COMM Status
indicator on the Configuration Mode
menu is off.
Place the logic controller in run mode
to resume communication.
16399 A fatal CPU fault
occurred
Critical Fault A fatal CPU fault occurred. Contact technical support.
16401 The RAM check
failed
Critical Fault RAM verification failed at startup. Contact technical support.
16402 The CRC check of
the firmware
failed
Critical Fault CRC verification failed at startup. Contact technical support.
16403 OS startup failed Critical Fault Operating system failed to start. Contact technical support.
16404 PV Client Task
Fault
Critical Fault Internal error has occurred. Contact technical support.
16405 Invalid preset
information
received from
motherboard.
Critical Fault Internal error has occurred. Contact technical support.
16406, 16407 Connection with
Addr or scan rate
invalid or no
connection being
attempted.
Critical Fault Internal error has occurred. Contact technical support.
16408 No buffers
available for read
operation
Critical Fault Internal error has occurred. Contact technical support.
16409 DC couldn’t send
out the write
request in time.
Critical Fault Too many write operations are
occurring.
Contact technical support.
16410 Too many clients
attempted to
connect to server
Critical Fault Internal error has occurred. Contact technical support.
16411 XS-WD creation
error
Critical Fault Internal error has occurred. Contact technical support.
16412 XS-WD start
error
Critical Fault Internal error has occurred. Contact technical support.
16413 ENet addr is not
valid
Communication
Warning
The EtherNet address for a device on
the EtherNet/IP network is invalid.
Contact technical support.
16414 Duplicate IP
address detected
Critical Fault The PanelView has the same IP
address as another device on the
EtherNet/IP network.
Change the IP address of the
PanelView (on the Communication
Setup screen) so that is unique on the
network.
16415 Unknown error
detected
Communication
Warning
An operating system message has
occurred.
Contact technical support.
16416 No network link Critical Fault Communication has not been
established with network.
Check Ethernet cable.
Error Number Terminal
Messages
Type Meaning Recommended Action
Zobrazit stránku 264
1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 291 292

Komentáře k této Příručce

Žádné komentáře