Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Uživatelský manuál stáhnout pdf (Strana 37)

Chapter 3

Installing the Software

3–11

restart your PC to activate your changes to the CONFIG.SYS and

AUTOEXEC.BAT files.

Configure Your PLC

Use Allen-Bradley’s 6200 Series PLC-5 programming software or the

EIBOOT utility to set the PLC’s IP address. Refer to the documentation that

came with your PLC for additional information on configuration.

If you have installed the Offline Programming Software without

PassThrough processing, your computer will return to the DOS prompt,

C:\DL40>. If you have installed PassThrough processing, your computer

will return to whatever directory it displayed when you began the

PassThrough processing installation.

If you do not return to the C:\DL40> directory, change directories by typing:

CD C:\DL40↵

You may then start the the Offline Programming Software program by

typing:

DL40↵

The communication port settings on your computer and the DL40 must be

the same in order to communicate.

• the port usage on the RS-485 port must be set to PRGMR to perform

message file transfers via the RS-485 port.

• the DL40 RS-232 port is always configured for communications with the

DL40 Offline Programming Software.

• set your computer’s serial communication port to the following:

– baud rate 9600

– data bits 8

– parity none

– handshaking none

• Use the [SELECT] and [ENTER] push buttons on the front panel of the

DL40 to select SET RS232 PORT?–PGMR/PRNTER SETUP or SET

RS-485 PORT?–PRGMR and set the parameters to match the setting of

your computer’s serial communication port.

Note: Select Enable DIP switch (SW2-9) must be ON.

• You can also change the settings of the DL40’s serial ports with the

[CTRL]R command using the DL40’s Onboard Editor and an IBM

compatible keyboard connected to the rear keyboard port of the DL40

display.

Starting the Program

Establishing Initial

Communications In

Non-Networked Installations

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 138 139

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Uživatelský manuál Strana 37

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA