Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Uživatelský manuál stáhnout pdf (Strana 33)

Chapter 3

Installing the Software

3–7

9 If you are using a card other than the 1770-KF2, the contents of the

CFG_KT.INI file should be similar to the format shown in the sample file

below. This sample is for a 1784-KT board:

[DTL_KT.Options] ①

PATH=C:\ABIC\BIN ②

③

[DTL_KT.1] ④

DEVICE=KT ⑤

MEMORY=C800 ⑥

PROTOCOL=DHPLUS ⑦

IRQ=5 ⑧

STATION=77 ⑨

NAME=DTL_KT 1 ⑩

In this file:

① This line identifies the file and prefaces a section of the file used to record

information common to all the communications interface cards on your

system.

② PATH line that designates the directory where the INTERCHANGE

server programs are located. This will be the same value for all interface

cards on your system.

③ Blank line to separate sections and improve readability.

④ This line identifies the general class of hardware device (in this case a KT

device) and a logical pushwheel identifier of 1. Note: The DL40 Offline

Programming Software assumes that pushwheel 1 is used. Use only

pushwheel 1 when communicating with the DL40 Offline Programming

Software.

⑤ DEVICE line that specifies the exact communication interface card used.

Acceptable values include KT, KTX, KL, KT2, or PCMK.

⑥ MEMORY line that matches the dip switch settings on the interface card.

⑦ PROTOCOL line that identifies the protocol in use.

⑧ IRQ line that matches the dip switch settings on the interface card.

⑨ STATION line designates the octal station address on the local

communications link.

⑩ NAME is a unique string you define to specify to this configuration.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 138 139

Žádné komentáře

Rockwell-automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUA Uživatelský manuál Strana 33