Rockwell-automation 22-COMM PowerFlex 4-Class DSI (Drive Serial Interf Uživatelský manuál stáhnout pdf (Strana 2)

Figure 1 Mounting and Grounding the Adapter – PowerFlex 40 Class Frames B and C,

and PowerFlex 400 Class Frame C

Step 3

If the adapter has address or data rate switches, and/or an Operating

Mode jumper, set them to appropriate positions. See the adapter User

Manual for complete details.

Step 4

Mount the adapter.

PowerFlex 40 Class Frames B and C, and PowerFlex 400 Class Frame C

A. Mount the adapter on the required special drive cover (see Figure 1 for

part numbers).

– Frame C: Use the adapter screw to secure the adapter to the cover.

Important: Tighten the adapter’s lower left screw to properly

ground the adapter (see Figure 1).

– Frame B: Disregard the screw and snap the adapter in place.

Important: Install the drive cover onto the drive using both cover

fasteners to properly ground the adapter.

B. Connect one end of the Internal Interface cable to the DSI port on the

drive and the other end to the mating DSI connector on the adapter

(Figure 2

PowerFlex 40 Drive

(Frame C shown as

example with cover removed)

Adapter Mounted on Back of

Required Special Drive Cover

(Frame C cover shown)

PowerFlex 40 Class Frame B: Part No. 22B-CCB

PowerFlex 40 Class Frame C: Part No. 22B-CCC

PowerFlex 400 Class Frame C: Part No. 22C-CCC

Ground for Frame C Drives

NOTE: For Frame B drives, the lower

left adapter screw does not ground the

adapter. To ground the adapter, install

the special drive cover onto the drive

using both cover fasteners.

0.9 N-m

(8.0 lb.-in.)

1 Place

1 2 3 4

Žádné komentáře

Rockwell-automation 22-COMM PowerFlex 4-Class DSI (Drive Serial Interf Uživatelský manuál Strana 2