Rockwell-automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM. Uživatelský manuál stáhnout pdf (Strana 13)

ControlNet Communication Interface Card 13

Publication

1784-5.33 – September 1997

4. If you are using the card’s default base I/O space addr

ess setting

, go to the

next section, Installing the Card Inside the Computer.

If you are setting a

new base I/O space addr

ess

, set the switches to the up or

down position to reflect the selected address from Worksheet E.

20629–M

up (1)

down (0)

Side ViewFront View

220h

Factory-set

address

(recommended setting)

Front of Switches

1234

up (1)

down (0)

24 ControlNet Communication Interface Card

Publication

1784-5.33 – September 1997

Important: If you are using a non-redundant cabling system, all ControlNet

devices must be on the same channel, channel

Connecting to a Device on the ControlNet Network

By using the card’

s RJ-45 connector (known as the network access port or

NAP), you can connect the card to a ControlNet network, without a tap, through

a programmable controller, I/O adapter, or another KTCX15 card (Figure 5 and

Figure 6).

The 1786-CP cable (Figure 4) connects a portable host computer to another

computer; it has two RJ-45 8-pin connectors.

Figure 4

1786-CP

cable

1786-CP cable

RJ-45 8-pin connectors

ATTENTION:

Use the

1786-CP

cable when connecting a

programming terminal to the network through the network access port

(NAP); using another cable could result in possible network failures or

product damage.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM. Uživatelský manuál Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 1784-KTCX15 INSTL INSTR CONTROLNET COMM.