Rockwell-automation 1771-DB BASIC MODULE Uživatelský manuál Strana 30

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 394
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 29
Chapter
Installing the BASIC Module
1
1 -6
Set Operating Mode Jumper (JW4)
Use JW4 to configure your communication ports as a program port, ASCII
port, network port, or DF1 protocol. Also configure your power on
operating condition. Refer to Chapter 2 for more information regarding the
operation mode.
If PRT1 is: and PRT2 is: and DH485 is: and action at power
up is:
Set jumper:
your selection:
ASCII port
ASCII port
program port
②④
executing program
program port
ASCII port
network
port
executing program
in Command mode
factory setting
DF1 protocol
disabled
executing program
If you previously executed a PROG2 (page 10 -13).
Mode settings of these ports determined by information you saved with a PROG1 (page 10 -12), PROG2, or MODE (page 11 -20).
Operating with default communication settings (1200, n, 8, 1, s). You may want to use this mode for troubleshooting purposes.
You must use PBASE software (1747-PBASE) if using the DH-485 port as the program port.
Chapter
Zobrazit stránku 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 393 394

Komentáře k této Příručce

Žádné komentáře