Rockwell-automation 1771-CFM Config. Flowmeter Installation Instructio Uživatelský manuál stáhnout pdf (Strana 6)

Configurable Flowmeter Module6

Publication 1771ĆIN043B-EN-P - July 2002

Place your module in any slot of the I/O chassis except for the

extreme left slot. This slot is reserved for processors or adapter

modules.

Use of data table 2Ćslot addressing 1Ćslot addressing 1/2Ćslot addressing

Input Image Bits

Place the CFM module in any

Output Image Bits 8

ace

CFM

n any

module group with any 8

bit or

ace

CFM

n any

module group with any 8

bit

no restrictions

Read Block Words 41 max

module group with any 8Ćbit or

block transfer module.

module group with any 8Ćbit

16Ćbit or block transfer module.

no restrictions

Write Block Words 60 max

b oc a s e od e

6b o boc a se od e

Key the Backplane

Connector

Observe the following

precautions when inserting or

removing keys:

• insert or remove keys with

your fingers

• make sure that key placement

is correct

Incorrect keying or the use of a

tool can result in damage to the

backplane connector and possible

system faults.

ATTENTION

Position the keying bands in the backplane connectors to correspond

to the key slots on the CFM module.

19808

Place the keying bands:

S between 2 and 4

S between 6 and 8

The CFM module's printed circuit board is slotted in two places on the

rear edge. These slots are intended to mate with the plastic keying bands

supplied with the I/O chassis.

Determine CFM Module

Placement

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Rockwell-automation 1771-CFM Config. Flowmeter Installation Instructio Uživatelský manuál Strana 6

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Rockwell-automation 1771-CFM Config. Flowmeter Installation Instructio