Rockwell-automation 1769-OF4CI CompactLogix 1769-OF4CI Module Uživatelský manuál stáhnout pdf (Strana 10)

10 Compact 1769-OF4CI Isolated Analog Output Module

Rockwell Automation Publication 1769-IN075B-EN-P - August 2010

Panel Mounting

Mount the module to a panel using two screws per module. Use M4 or #8

panhead screws. Mounting screws are required on every module.

Panel Mounting Using the Dimensional Template

Panel Mounting Procedure Using Modules as a Template

The following procedure lets you use the assembled modules as a template for

drilling holes in the panel. If you have sophisticated panel mounting equipment,

you can use the dimensional template provided on page 10

. Due to module

mounting hole tolerance, it is important to follow these procedures.

1. On a clean work surface, assemble no more than three modules.

2. Using the assembled modules as a template, carefully mark the center of

all module-mounting holes on the panel.

3. Return the assembled modules to the clean work surface, including any

previously mounted modules.

4. Drill and tap the mounting holes for the recommended M4 or #8 screw.

5. Place the modules back on the panel, and check for proper hole

alignment.

Spacing for single-wide modules 35mm (1.378 in.)

Spacing for one-and-a half-wide modules 52.5mm (2.067 in.)

Refer to host controller documentation for this dimension.

Host Controller

ote: Overall hole spacing

olerance: ±0.4mm (0.016 in.).

30535-

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Žádné komentáře

Rockwell-automation 1769-OF4CI CompactLogix 1769-OF4CI Module Uživatelský manuál Strana 10