Rockwell-automation Logix5000 Systems: Connecting PowerFlex 40 Drives Uživatelský manuál stáhnout pdf (Strana 17)

Rockwell Automation Publication IASIMP-QS029A-EN-P - February 2012 17

Prepare the PowerFlex 40 Drive Hardware Chapter 1

Connect the EtherNet/IP Adapter to the Drive

1. Before you connect the adapter

to the 22B-V2P3N104 drive,

record the Ethernet (MAC ID)

address.

You need this number to set an

IP address for the adapter, as

described in Configure the EtherNet/IP Adapter

on page 19.

The MAC ID address uses format xx:xx:xx:xx:xx:xx where each x represents a letter

or numeral. The MAC ID is located on the adapter’s product ID label as shown in the

example graphic.

2. Mount the adapter on the drive cover.

3. Connect the Internal Interface

cable to the DSI port on the

drive.

4. Connect the mating DSI

connector on the adapter.

WARNING: Verify that all incoming power is turned off before connecting the adapter to the drive.

IMPORTANT

You must use either a 22B-CCB Frame B drive cover or 22B-CCC Frame C drive cover with the PowerFlex 40

drive. These tasks use a Frame B drive cover.

22-COMM - E

00:00:BC:08:90:65

22-COMM-E

HW Address: 00:00:BC:08:90:65

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Žádné komentáře

Rockwell-automation Logix5000 Systems: Connecting PowerFlex 40 Drives Uživatelský manuál Strana 17