Rockwell-automation LDAT Integrated Linear Thrusters Uživatelský manuál stáhnout pdf (Strana 70)

70 LDAT-Series Integrated Linear Thrusters

Rockwell Automation Publication LDAT-IN001A-EN-P - August 2012

Hookup Test

1. Run RSlogix 5000 software.

2. Double-click on the axis to show the Axis Properties for your linear thruster.

3. Click Hookup tab.

4. Set Test Increment to 60 mm.

5. Click Test Feedback.

Follow prompts to complete the test.

Remove Encoder Scale

1. Remove the scale and stainless steel backer.

2. Clean the scale alignment groove with isopropyl alcohol to remove all of the adhesive

residue.

3. Dry thoroughly.

Install Encoder Scale

1. Place the paper-backed scale into the groove.

2. Mark off a length that is 0.8 mm (0.03 in.) shorter than the encoder scale groove length.

3. Repeat step 2 with the stainless steel backer.

4. Remove the paper backing from the stainless steel backer and place the backer in the

groove.

5. Remove the paper backing from the encoder scale tape and place the scale tape on the

stainless steel backer.

IMPORTANT

Lay the stainless steel backer flat to the slider. If the scale is not flat, the encoder scale

will rub on the encoder.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 79 80

Žádné komentáře

Rockwell-automation LDAT Integrated Linear Thrusters Uživatelský manuál Strana 70