Rockwell-automation FactoryTalk Historian SE 3.0 Live Data Interface U Uživatelský manuál stáhnout pdf (Strana 17)

Chapter 3

Configuring FactoryTalk Historian Live

Data Interface

To configure a FactoryTalk Historian Live Data Interface (FTLD), we

recommend that you use FactoryTalk Administration Console.

However, you must use the Interface Configuration Utility (ICU) to

configure an FTLD Interface in the following cases:

 If you are configuring redundant FTLD Interfaces.

For more information, refer to the 59932 article at the Rockwell

Automation Knowledgebase

(https://rockwellautomation.custhelp.com/app/answers/detail/a_id/599

32).

 If you are configuring the buffer subsystem on an FTLD Interface.

For more information, refer to "Enable Buffering" in the FactoryTalk

Historian SE Installation and Configuration Guide.

Enabling the buffer subsystem is a recommended step during the

installation of the FactoryTalk Historian Live Data Interface. To take

advantage of this feature, you must install the FTLD Interface on a separate

machine than the FactoryTalk Historian SE.

 If you are configuring the Disconnected Startup option.

For more information, refer to "(Unint) Disconnected Startup" in the

Interface Configuration Utility Help.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 61 62

Žádné komentáře

Rockwell-automation FactoryTalk Historian SE 3.0 Live Data Interface U Uživatelský manuál Strana 17