Rockwell-automation DeviceLogix System User Manual Uživatelský manuál stáhnout pdf (Strana 157)

Publication RA-UM003B-EN-P - February 2010 157

Create Logic in the New Ladder Editor Chapter 7

To view the Macro block parameters, choose Tools > Macro >

Open Macro Definition, and click the Parameter tab.

Consider these guidelines when editing the Macro definition.

• Nested Macro block configuration is not supported. While you

configure Macro block logic, all Macro block instructions in the

Instruction toolbar are grayed-out so that you cannot add a

Macro within a Macro definition.

• You may copy and paste logic from the main logic window to

the Macro tabbed window, assuming that the copied logic

doesn't contain any Macro instructions. When you copy and

paste from the main logic window, all I/O bindings will be

removed.

• You may copy and paste logic from the Macro tabbed window

to the main logic window. When you copy and paste from the

Macro tabbed window, all I/O bindings will be removed.

• Copying and pasting logic will set all contact, coil, or analog I/O

to unbound.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 208 209

Žádné komentáře

Rockwell-automation DeviceLogix System User Manual Uživatelský manuál Strana 157