5Ć1
&
NOTE:
""
!"
"
"
This chapter describes how to install the sharedĆuser version of the
Executive software, which allows up to five users to run the
Executive simultaneously (M/N 57C625, M/N 57C626). Installation of
the sharedĆuser Executive requires two separate procedures.
The first procedure, in section 5.1, describes how to install the
Executive on the network file server. This procedure must be done
first.
The second procedure, in section 5.2, describes how to install the
Executive on each network node that will use the Executive
software.
During the installation procedure, the following subdirectories will be
created on the network server hard disk if they do not already exist:
<DRV>:\RPE\<AMX4>
<DRV>:\RPE\<AMX4>\TEMP
For DPS Software Users:
If you install sharedĆuser Executive software and you want to install
any DPS software options, you must first install the sharedĆuser DPS
software. See chapter 8 for more information.
!!& %"!#
!$#
Install the sharedĆuser Executive on a network server following the
directions below. This procedure must be performed before
installing the sharedĆuser Executive on each network node.
Step 1. To begin installing the Executive software, insert the disk
labeled 1" in floppy drive A: or B:.
Click Start, then click Run, and then type:
ą<DRV>:\INSTALL.EXE
where:
ą<DRV> is the floppy drive in which you have placed
ąthe disk.
Click OK" to begin the install procedure.
Before installing any files, the install program will perform
a setup operation, and then display messages describing
the type of installation (Shared 5 User or Shared 5 User
Upgrade) and the amount of hard disk space required for
the Executive software.
Komentáře k této Příručce