Rockwell-automation 8510 Hardware/Firmware Replacement Instructions Uživatelský manuál stáhnout pdf (Strana 2)

8510 Hardware/Firmware Replacement

Instructions

o 1. Display & Keypad Module Replacement

a) Assure that all power has been removed and 30 seconds has elapsed.

b) Remove the drive front cover. See ESD precaution on page 1 and

apply grounding wrist strap.

c) Label and remove any cables from the I/O Board. Remove the I/O

Board by taking out the four corner mounting screws and carefully

separating the connectors.

d) Remove the Display & Keypad Module (from the I/O Board) by

taking the four screws (that secure the assembly) out from the back of

I/O Board and carefully separate the connector.

e) Install the new module by reversing the above steps.

f) Replace drive cover, remove wrist strap and check for proper

operation.

1 2 3 4 5 6 7 8

Žádné komentáře

Rockwell-automation 8510 Hardware/Firmware Replacement Instructions Uživatelský manuál Strana 2