Rockwell-automation 5370-UPK CVIM USER-PAK Option Uživatelský manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 142
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
Chapter 3
Installation
32
firmware revision is listed on the title banner on the monitor screen
following powerup).
OneTime Installation: You need only install the USERPAK option once;
once installed, the USERPAK option remains installed for all subsequent
powerups.
To install the USERPAK option in your CVIM module:
Remove DC power from the CVIM module by pulling out the DC PWR /
LOCK handle on the power supply module as far as it will go.
Insert the Installation / Key card into the Archive Memory slot on the
CVIM module. Insert the end with the metal strip facing right:
CVIM Module
Card Label Metal Strip
USER–PAK
Installation/Key card
Push in the DC PWR / LOCK handle as far as possible. This applies DC
power to the CVIM module, and starts the loading sequence.
Do not remove power to the CVIM module during loading
of the USERPAK option. Doing so may damage the
CVIM module.
CAUTION:
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 141 142

Komentáře k této Příručce

Žádné komentáře