Rockwell-automation 2711P PanelView Plus Terminal User Manual Uživatelský manuál stáhnout pdf (Strana 183)

Publication 2711P-UM001J-EN-P - November 2009 183

Terminal Connections Chapter 7

Minimum Requirements

The software and firmware must be installed on the development

computer and the PanelView Plus terminal to configure and

communicate with an Allen-Bradley controller on a ControlNet

network.

ControlNet Unscheduled Communication

ControlNet Scheduled Communications

Software/Firmware PanelView Plus 700 to 1500 PanelView Plus 400 or 600

FactoryTalk View Studio Version 3.10 or later Version 4.0 or later

FactoryTalk View Machine Edition Runtime Version 3.10 or later Version 4.0 or later

ControlNet Module Firmware 2711P-RN15S, Series A, Rev A

(firmware version 2.07 or later)

(1)

2711P-RN15C, Series B, Rev A

or later

(1)

This applies to terminals that are ordered as pre-configured units with the ControlNet module.

Requirements PanelView Plus 700 to 1500 PanelView Plus 400 or 600

FactoryTalk View Studio Version 3.20 or later Version 4.0 or later

FactoryTalk View Machine Edition Runtime Version 3.20.04 or later Version 4.0 or later

RSNetWorx for ControlNet Version 5.11 or later Version 6.0 or later

RSLogix 5000 Version 13.0 or later Version 15.0 or later

ControlNet Module Firmware 2711P-RN15S, Series A, Rev C

(firmware version 3.08 or later)

(1)

2711P-RN15C, Series B, Rev A

or later

(1)

This applies to terminals that are ordered as preconfigured units with the ControlNet module.

WARNING

The ControlNet Communications Module, cat. no.

2711P-RN15S, will not run with FactoryTalk View ME firmware

version 3.20.04 or earlier. All ControlNet Modules with version

3.07 firmware must be upgraded to version 3.08 or later;

otherwise, outputs may turn on an indeterminate state.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 245 246

Žádné komentáře

Rockwell-automation 2711P PanelView Plus Terminal User Manual Uživatelský manuál Strana 183