Rockwell-automation 2711E-NK5 Replacing the PanelView 1400E Keypad Fac Uživatelský manuál stáhnout pdf (Strana 4)

Replacing the PanelView 1400e Keypad Faceplate4

4. Disconnect the cable from the controller board on the keypad

faceplate. Note the position and orientation of the cable so that

you can reconnect it properly.

5. The keypad faceplate is attached to the terminal by six Phillips

screws, three on each side. Use the No. 2 Phillips screwdriver to

remove them. The location of the screws is shown above.

6. When you have removed all the screws, tilt the unit up into

operating position, holding the faceplate in place. Gently set the

terminal on its bottom.

1 2 3 4 5 6 7 8 9 10 11

Žádné komentáře

Rockwell-automation 2711E-NK5 Replacing the PanelView 1400E Keypad Fac Uživatelský manuál Strana 4