Rockwell-automation 2711C-xxxx PanelView Component HMI Terminals Quick Uživatelský manuál stáhnout pdf (Strana 40)

40 Publication 2711C-QS001F-EN-P - November 2010

Chapter 4 Configure Communication

Configure Ethernet Communication

This topic shows how to configure runtime settings to enable Ethernet communication between your

PanelView Component terminal and a MicroLogix 1100 controller. It is not necessary to configure settings

for the terminal if using DHCP-enabled network IP addresses.

1. Click the Communication

tab to open the

Communication view.

2. Select Ethernet under

Protocol.

3. Select Allen-Bradley

Micrologix/ENI from the

pull-down list.

TIP

If the target terminal for an application uses a static IP network address, you would enter the

address on the USB/Ethernet tab.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 109 110

Komentáře k této Příručce

Žádné komentáře